|
We have the following THREE Hydraulic Cylinders Available:
Email Us With Any Questions Or Requests!
We have the following Two USED (identical) hydraulic cylinders available:
These cylinders have been sitting on a shelf in our shop for a while. They are not leaking fluid as they
sit on the shelf but the seals may have to be replaced in order to hold the fluid when pressure is applied to them.
These cylinders can stroke out 18 inches each way via a single ram. In other words - if you are stroked out 18 inches to
the left .... you would be stroked out 0 on the right side. - If you you are stroked out 10 inches to the right .... you would
be stroked out 8 inches to the left.
These jacks have a 6 1/4" OD shoe that fit over a 3 1/4" OD
Ram shoe at each end. The 6 1/4" OD shoe can be bolted to an object so that as the ram is extended or retracted; the
attached object can be pushed or pulled.
The Cylinder body has four mounting frame holes so that the cylinder body
can be bolted down and secured.
Top view - Cylinder body is 8-1/2" wide (from mounting bracket to mounting
bracket)
The cylinder is 52 inches in total length (From right side shoe fully retracted to left side
shoe fully extended)
The cylinders were manufactured by The W. E. Hennells Company Belleville, Michigan.
The metal tag has the following information on it.
The Company Manufacturer (as referenced above)
Model DH-141 - Serial Number 18123
Bore 4" - Stroke 18"
Each ram weighs 150 pounds
Each cylinder has a Waterman Hydraulics Corporation - Skokie, IL - Model 661-4 - Serial Number 548874 - Pilot operated check
valve with a 3000 psi operating pressure.
Please see the pictures below:
|
| W. E. Hennells Hydraulic Cylinder - 52 inches total length from far right to far left |
|
| 8 1/2" width from outside of mounting bracket to outside of mounting bracket |
|
| W. E. Hennells Hydraulic Cylinder |
|
| W. E. Hennells Hydraulic Cylinder |
|
| Pic showing how shoe slides over ram shoe |
|
| UNDERSIDE of The W.E. Hennells Hydraulic Cylinder |
|
| Metal Tag for The W.E. Hennells Hydraulic Cylinder |
|
| Waterman Pilot Operated Check Valve |
We also have the following USED hydraulic cylinder available:
This
cylinders has been sitting on a shelf in our shop for a while. It is not leaking fluid as it sits on the shelf but the
seals may have to be replaced in order to hold the fluid when pressure is applied to it.
This cylinder is a Pickens
- Single acting Model MD6476 - 6 1/2" bore - 20" stroke
The retracted total height is 30 inches - The
clyinder base OD is 7 3/4" - The cylinder weighs 175 pounds
Please see the pictures below:
|
| Pickens Hydraulic Cylinder |
|
| Pickens Hydraulic Cylinder |
|
| Pickens Hydraulic Cylinder |
|
| Pickens Hydraulic Cylinder |
|
| Pickens Hydraulic Cylinder |
|
